Advertisement

BMW warns owners of 720,000 cars of fire risk after earlier repair failed to resolve problem

BMW iX3 M60 xDrive
Fullscreen image

BMW has recalled 720,796 vehicles in the US because the engine’s electric water pump connector could cause a fire even with the ignition switched off. Authorities advise owners to park away from buildings and other vehicles. Particularly problematic is the fact that the same cars were already subject to a recall in 2024, but the repair carried out then failed to eliminate the fire risk.

Advertisement

Water pump connector could cause a short circuit

According to a warning from the US National Highway Traffic Safety Administration (NHTSA), the problem concerns the electrical connector on BMW’s electric water pump.

Over time, the connector’s plastic material can become brittle and crack, allowing moisture to reach the electrical contacts. This can lead to a short circuit, overheating and, in the worst case, a fire.

The risk is not limited to when the engine is running. An electrical fault can also cause a fire in a parked car, which is why NHTSA recommends keeping the vehicles outdoors and away from buildings and other cars until they have been repaired.

BMW estimates that the defect is actually present in fewer than 0.1 per cent of the vehicles covered by the recall.

The company is aware of around ten incidents in the US potentially linked to the fault. No accidents or injuries have been recorded so far.

First recall failed to resolve the problem

BMW carried out an extensive service campaign for the same defect in 2024.

At the time, dealers fitted an additional cover to protect the water pump’s electrical connection by directing liquids away from the connector. Where necessary, mechanics also replaced the water pump or wiring.

  • In 2025, however, further cases of overheating emerged in cars that had already undergone the earlier campaign’s repairs.

BMW then began more detailed material testing. Laboratory tests revealed severe embrittlement and cracking in the connector’s polybutylene terephthalate (PBT) components.

Engineers investigated, among other possibilities, whether prolonged exposure to moisture was damaging the material. However, the precise degradation mechanism is not yet fully understood.

The new recall shows that the original repair focused mainly on preventing moisture from reaching the connector, but did not adequately address the possibility of damage to the connection itself.

Problem affects ten BMW model families

The recall covers vehicles built between 2012 and 2018, including the following models:

  • BMW 2 Series: 2014-2016.

  • BMW 3 Series: 2012-2016.

  • BMW 4 Series: 2014-2016.

  • BMW 5 Series: 2012-2016.

  • BMW X1: 2012-2015.

  • BMW X3: 2013-2017.

  • BMW X4: 2015-2018.

  • BMW X5 xDrive40e: 2016-2018.

  • BMW Z4: 2012-2016.

The problem does not affect every engine and equipment variant of these models. The recall focuses on vehicles fitted with a particular electric water pump.

The largest groups are 3 Series saloons, with around 237,000 included in the campaign, and X3 SUVs, with more than 163,000.

No definitive repair yet

BMW has not yet confirmed what technical change it will make to resolve the problem definitively.

The manufacturer is developing a new repair and will carry out all recall-related work free of charge.

BMW will begin sending notification letters to US owners on 25 December. From the same date, owners will be able to check whether their car is included in the campaign by entering its vehicle identification number, or VIN, in the NHTSA database.

Until repairs are carried out, authorities advise owners to park outdoors.

Does the problem also affect BMWs in Europe?

Although the new recall officially covers US vehicles, BMW also has models from the same period in the European market.

This is particularly important for used-car owners, as some of the affected vehicles are already more than ten years old.

The US campaign does not automatically mean that all European cars carrying the same model name are also unsafe. Each vehicle’s VIN and the manufacturer’s local service campaigns need to be checked.

In Estonia, this can be done through an authorised BMW service centre.

The case shows that even a relatively simple electrical connection can become a serious safety problem if its materials cannot withstand prolonged exposure to heat, moisture and vibration.

The most troubling aspect for BMW is that the first repair proved inadequate. The manufacturer must now find a solution that eliminates the fire risk rather than merely reducing the likelihood of a fire.