Advertisement

Toyota’s sponge device halves winter test-track drying time

La idea de Toyota basada en una esponja para secar sus pistas de pruebas 1/5
Fullscreen image 1/5

Toyota is using a two-metre-wide sponge device at its Higashi-Fuji Technical Centre in Japan to resume braking tests more quickly after rain. According to the manufacturer, winter track-drying time has fallen from around four hours to two, saving approximately 91 working hours a year.

Advertisement

A dry track is part of the test conditions

Toyota tests its Pre-Collision System (PCS) on the third straight at the Higashi-Fuji Technical Centre in Susono. Precision systems control the steering, accelerator and brakes of instrumented cars, allowing different scenarios to be simulated. The tests described here require a dry road surface, so after rain the team must wait until the track is in a suitable condition again.

This does not mean Toyota does not test PCS on wet roads: the manufacturer distinguishes wet-road tests from those that require a dry surface. The sponge device is intended specifically to reduce the waiting time before the latter.

The solution is not new. According to Toyota’s earlier account, development began in October 2023 and the device was in use by the end of March 2024.

  • Application: PCS tests requiring a dry track at Toyota’s Higashi-Fuji Technical Centre in Japan.

  • The sponge device is approximately two metres wide, and its aluminium water tank holds around 320 litres.

  • When turning, a cable mechanism lifts the sponge off the road surface without a separate electric actuator.

  • According to Toyota, winter drying time fell from around four hours to two.

  • The manufacturer estimates that the solution saves approximately 91 working hours a year.

Two metres of sponge and a 320-litre water tank

The idea originated when test team adviser Kazutoshi Takeda saw water being removed from a baseball field after rain on television. Toyota employees built a small prototype from materials available on site and arrived at the final design after seven versions.

A sponge approximately two metres wide collects water from the track. A steel component squeezes the water out of the sponge, and it is channelled into an aluminium tank holding around 320 litres.

One development challenge was to prevent the sponge from wearing during turns. The solution was a karakuri mechanism: a cable that tightens as the vehicle turns lifts the sponge off the asphalt. No separate motor or electrical components are needed to lift it.

However, the absence of an electric lifting actuator does not mean the drying process uses no energy, as the device is towed by a car.

The fastest method was not chosen

The developers also considered heating the road surface, suction, blowers and solutions working on the same principle as a windscreen wiper. In Toyota’s own tests, suction removed water fastest, but the manufacturer judged that scaling up the small prototype to cover the required length of track would have been too expensive. The ability to develop and build the sponge solution in-house counted in its favour. Toyota has not published performance figures for the devices compared or the test protocol.

According to Toyota, drying the track in winter takes two hours rather than the previous four or so. In summer, it takes an hour to an hour and a half with the device. Three teams use the track, and the manufacturer puts the annual working-time saving at approximately 91 hours.

These results reflect Toyota’s own working arrangements, rather than an independent efficiency test. The area dried, the thickness of the water layer, comparable weather conditions and the calculation behind the 91-hour figure have not been published. These figures therefore cannot be used to assess the device’s cost-effectiveness or performance at other test tracks.