Advertisement

New zinc–iodine battery retains 94% capacity after 2,000 charging cycles

Battery
Fullscreen image

British researchers have developed a water-based zinc–iodine battery that retained 94% of its initial capacity after 2,000 charge–discharge cycles in laboratory tests. The key to the new approach lies in an electrolyte that allows iodine to store more energy without using highly corrosive halogen-containing mixtures. The technology could eventually offer an alternative to lithium-ion batteries, particularly in large stationary energy storage systems.

Advertisement

A study by researchers at University College London (UCL) and the University of Oxford has been published in the journal Nature. Its focus is not a new battery material, but a way to make iodine work more efficiently and reliably in a water-based battery.

The results are promising, but the technology is still at the laboratory testing stage. The researchers have yet to demonstrate that the same durability and performance can be maintained in industrial battery systems.

Four electrons instead of two

Zinc–iodine batteries are a type of aqueous battery, using a water-containing solution instead of the conventional flammable organic electrolyte.

This approach offers the potential to reduce fire risk and use relatively widely available materials. Until now, however, the development of zinc–iodine batteries has been held back by limited energy density and iodine's instability during charging.

In a conventional zinc–iodine battery reaction, iodine can participate in a two-electron transfer. The UCL researchers managed to modify the reaction so that iodine participates in a four-electron transfer.

This doubles iodine's theoretical specific capacity from 211 milliamp-hours per gram to 422 milliamp-hours per gram.

It is important to understand, however, that this is a theoretical figure for iodine as an active material. It does not mean that the energy density of the entire battery doubles, because a finished battery contains electrolyte, current collectors, separators and a casing as well as electrodes.

The four-electron reaction does, however, allow more electrical charge to be stored using the same amount of iodine. This is an important step towards improving the energy density of aqueous batteries.

The biggest problem was water itself

Developing an aqueous zinc–iodine battery presents a particular contradiction. Water helps make the battery safer, but can also hinder the chemical reactions needed to achieve greater capacity.

The four-electron transfer produces highly reactive forms of iodine that tend to react with water. These side reactions reduce battery efficiency and accelerate capacity loss.

Previous experiments have addressed the problem using electrolytes containing high concentrations of chlorides or bromides. These help stabilise reactive iodine species, but can be corrosive and expensive.

The UCL researchers took a different approach.

They developed an electrolyte whose ingredients perform several functions at once. Some create an environment near the electrode that limits water access. Others help stabilise the reactive forms of iodine so that they do not break down through unwanted reactions.

This allows the four-electron iodine reaction to be used without the highly concentrated halide-containing electrolytes used previously.

The result is a battery that can make better use of iodine's energy storage potential.

2,000 charging cycles with 94% capacity retained

The new electrolyte's durability was assessed through repeated charging and discharging tests.

At a current of 1 amp per gram of active material, the zinc–iodine batteries retained 96% of their initial capacity after 1,000 cycles.

In a second test, at a current of 2 amps per gram, 94% of capacity was retained after 2,000 cycles.

These are strong results under laboratory conditions, particularly given that the researchers used a more complex four-electron reaction to achieve greater capacity.

However, the two results were not obtained under exactly the same conditions. They therefore cannot be treated as successive ageing measurements of a single battery.

The researchers tested the approach in both small coin cells and larger pouch cells. This showed that the electrolyte's effectiveness was not limited to a single laboratory cell design.

Nevertheless, successful testing in different cell types does not yet amount to a finished industrial battery.

How does the new approach compare with other zinc batteries?

Several research groups are developing zinc–iodine batteries, and UCL's achievement is not the only example of this battery chemistry's potential for a long service life.

Advertisement

A study by Chinese researchers published in September 2026 used a different approach, focused on reducing side reactions between the electrodes. In that test, a zinc–iodine battery achieved up to 50,000 charging cycles at a current of 5 amps per gram.

In another study, published in Advanced Materials, a battery based on a four-electron iodine reaction retained 78.8% of its capacity after 12,000 cycles at a current of 5 amps per gram.

These results show that there are several effective ways to improve the longevity of zinc–iodine batteries.

However, cycle counts alone cannot automatically establish that one approach is better than another. The test currents, amounts of active material, electrode designs and reactions used differ. A long-term test at a high current may not produce the same result at a slower charging rate or in a higher-capacity cell.

The main strength of UCL's approach therefore lies primarily in combining a four-electron iodine reaction with a relatively stable aqueous electrolyte.

Could zinc–iodine batteries replace lithium batteries in electric cars?

The development of new battery chemistries is important for the automotive industry, but this study does not yet give grounds to expect an electric car battery revolution.

High energy density is crucial in electric cars: as much energy as possible must be stored in a battery pack with as little mass and volume as possible.

Aqueous zinc batteries face a significant challenge here. Although the new electrolyte helps make better use of iodine's capacity, the researchers have yet to prove that the energy density of the complete battery system can compete with the lithium-ion batteries in today's electric cars.

There are also insufficient comparable data on battery mass, charging speed, temperature tolerance and production costs.

For now, stationary energy storage is a much more realistic application.

At solar and wind farms, for example, battery mass is not as critical as it is in a passenger car. Cost, safety, service life and the ability to withstand years of repeated charging and discharging are more important.

Here, aqueous batteries could offer serious competition to lithium iron phosphate, or LFP, batteries, which are already widely used in both electric cars and large energy storage systems.

LFP technology benefits from a mature production chain and a proven track record in use. The potential strengths of zinc–iodine batteries, meanwhile, are an aqueous electrolyte with a lower fire risk and the use of potentially cheaper materials.

Whether this translates into an actual cost advantage depends largely on production scale, cell energy density and the cost of the complete storage system.

The next challenge is moving beyond the laboratory

UCL chemistry professor Guanjie He, who led the study, regards the results as a step towards wider adoption of aqueous batteries.

The next stage is to test larger cells and assess their performance under conditions resembling those encountered in real energy storage systems.

This means, among other things, longer-term tests, larger quantities of active material, and assessments of how the electrolyte and electrodes behave under different operating conditions.

The researchers also showed that the same principle of electrolyte chemistry can be applied to aluminium–iodine batteries. This broadens the potential applications, but does not yet mean that the aluminium-based approach is ready for production.

The study's most important conclusion is therefore not that a direct replacement for lithium batteries has already been found.

Rather, the researchers demonstrated how changing an electrolyte's molecular composition can enable a more energy-rich chemical reaction in an aqueous battery while maintaining good cycle durability.

If this can be transferred to larger, economically competitive battery systems, zinc–iodine technology could help make renewable energy storage safer and more affordable in the future.